Jeep Wrangler Brake Pedal Goes To Floor

Adding fluid to the reservoir does nothing.

Jeep wrangler brake pedal goes to floor.

2008 jeep wrangler brake issues. My brake pedal goes all the way to the floor at time and i have to pull the emergency brake to stop. Her jeep setup for about 3 months and when we started it up the pedal went to the floor so i checked everything because i just put all new brakes around it before she parked it new pads new shoes. You might even have air in the abs module.

That will cause the brake to go to the floor. Check the brake fluid level. And the ability to be a contortionist lol. And you get to lay upside down on your drivers seat with your shoulders on the floor to reach up under the dash and take the cotter pin out of the pin that holds the brake pedal to the master cylinder rod.

I rolled back a bit to see if i had any brakes at all and i did. Don t mean to jack his post but my wife s is doing the same thing. Using a flashlight check the level of the fluid or just remove the lid of the reservoir and look inside. Anytime you have a brake pedal that goes to the floor raise the hood and locate the brake master cylinder s reservoir.

If the fluid is full then continue onto brake fluid is full down further in this guide. You need line wrenches for the 2 brake lines on the master. New wheels cylinders new calipers. The new caliper will have air pockets as well as the brake line to that wheel.

The 2016 jeep wrangler has 1 problems reported for brake pedal goes to floor. A few mornings ago i started the 4 7 ho up and put my foot on the brake to shift out of park and the pedal went to the floor. You didn t mention doing so. Simple job with the proper tools.

Just as a cautionary note when you open close the brake lines don t push the pedal straight to the floor. I have bled the brakes and the problem was not resolved. So i went for a careful drive and the jeep stops very good but now the pedal has to be pushed all the way down.